Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in St. George?
Chimney repair in St. George typically runs $185 to $650 for common fixes like a cracked crown, a loose cap, or masonry pointing, while larger jobs such as a flue liner replacement land between $1,400 and $3,600. A full chimney rebuild or a firebox rebuild is the outlier, usually $4,000 to $9,500 depending on how much of the stack needs to come down. Those are the ranges homeowners see across Washington County, and the written estimate is what sets the final number for your specific chimney.
What makes St. George its own pricing picture is the climate and the housing. This is high desert: intense UV, big temperature swings between a hot afternoon and a cold night, and building materials that bake and then cool hard every day. That cycle opens mortar joints and hairline cracks in ways a wetter, milder climate doesn’t. A lot of the homes here were also built in the last few decades with wood-framed chases and factory-built fireplaces rather than solid masonry, and those two chimney types fail differently and price differently. We’ll walk you through both below.
If you’d rather skip to booking a visit, the estimate is free and the price is set per job by the written estimate once we’ve seen your chimney. Call (877) 327-1971. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Chimney Repair Cost Breakdown (2026)
These ranges reflect what typical repair work runs in the St. George market in 2026. Every chimney is different, so treat these as a starting point for planning, not a quote.
| Repair | Typical Estimated Range |
|---|---|
| Crown repair or replacement (cracked, pitted, or separating) | $275 – $850 |
| Chimney cap or top damper install | $185 – $650 |
| Tuckpointing / repointing mortar joints | $350 – $1,200 |
| Flashing repair or replacement (leak at the roof line) | $250 – $975 |
| Smoke chamber repair | $400 – $1,500 |
| HeatShield ceramic liner resurfacing | $1,100 – $2,200 |
| Flue liner replacement (stainless, full run) | $1,400 – $3,600 |
| Firebox rebuild | $1,250 – $3,200 |
| Masonry rebuild (partial to full stack) | $4,000 – $9,500 |
| Chimney sweep and inspection (often paired with repair) | $95 – $285 |
What pushes a job toward the high end? Height and access first. A chimney on a single-story home with an easy roofline is a different job than a tall stack on a steep pitch, and scaffolding or extra safety setup adds labor. Material choice matters too. We work with professional-tier product lines including DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, and the difference between a proper stainless liner system and a piecemeal substitute shows up in both the price and how long the repair lasts.
What brings a job down is catching it early. A cracked crown that gets sealed before water works its way into the masonry is a modest repair. The same crown left alone lets freeze-thaw and daily heat swings open the joints below it, and that’s when a crown turns into tuckpointing turns into a partial rebuild. The single biggest cost driver on almost every chimney we see is how long a small problem was allowed to sit.
What Affects Chimney Repair Pricing in St. George
Six things move the number more than anything else on a St. George chimney.
- Chimney type: masonry vs. factory-built. Solid brick and mortar chimneys need masonry work, crown repair, and sometimes a full reline. Factory-built fireplaces with a metal chase and a framed enclosure need different parts, and a cracked or failing chase cover or a rusted-out liner is common on older builds. The two never share the same price.
- How the desert climate has treated it. St. George gets relentless summer sun and wide day-to-night temperature swings. Mortar and crowns take a beating from that cycle, and UV breaks down sealants and caps faster here than in a mild climate. Chimneys on full-sun exposures tend to need attention sooner than shaded ones.
- Roof pitch and chimney height. A steep roof means more setup, more safety gear, and more time. A tall stack means more material on a reline and more labor on any masonry repair.
- Water intrusion and flashing. Leaks at the roof line are one of the most common reasons people call us. Flashing that’s failed lets water into the chase or the masonry, and where that water has been getting in determines how much repair is needed behind it.
- Liner condition. A compromised clay tile liner can sometimes be restored with HeatShield ceramic resurfacing rather than replaced outright. That decision alone is often the difference between a $1,100 job and a $3,000 one, and it depends on the condition we find during the inspection.
- Whether the work can happen in one visit. When the right parts are on hand, a lot of repair and liner work gets done in a single visit rather than spread across a special order and a return trip. Fewer visits usually means less total labor and less disruption for you.
Why Chimney Repair Costs What It Does in St. George
Homeowners who’ve just moved here from a wetter part of the country often assume their chimney will age the way it did back home. It doesn’t. The high-desert pattern of hot days, cool nights, and very dry air stresses masonry differently: materials expand and contract daily, mortar that’s already a little brittle starts to crumble at the joints, and a small crack at the crown invites water in during the occasional rain event. Then the sun comes back and dries it out fast, and the cycle repeats. That’s why tuckpointing and crown work show up so often on St. George chimneys, and why catching a crack early pays for itself.
Wood-framed chases are their own story. On a lot of newer subdivisions, the “chimney” you see from the street is a framed enclosure with a metal firebox and a manufactured flue inside. The failure points there aren’t mortar joints so much as chase covers, terminations, and the liner system itself. Repairing one is a parts-and-fit job, and it’s a big part of why we keep DuraFlex flexible liner systems on hand rather than special-ordering them. When a liner needs replacement, flexible stainless lets us complete the install in one visit on most runs.
There’s an honest question we get a lot: is it cheaper to repair or to replace? For a liner, resurfacing with HeatShield is often the lower-cost path when the existing flue is intact enough to resurface. For a masonry stack that’s lost whole courses of brick, repair can reach the point where it no longer makes sense and a rebuild is the smarter spend. We’ll tell you which one you actually need, and we’ll show you why. A clean chimney and a safe chimney aren’t always the same thing, and a repair that’s cosmetic when the real problem is structural doesn’t do you any favors. If you want the broader picture on how cleaning and inspection fit in, our Glacier Chimney Sweep pages cover the full scope of what we do.
How to Save on Chimney Repair
The best savings on chimney repair are almost never a discount. They come from timing and from knowing what actually needs fixing.
- Repair before it spreads. Seal a small crown crack now and you avoid the tuckpointing and rebuild it turns into later. The math on early repair is the single biggest lever you have.
- Get a real diagnosis, not an upsell. Plenty of homeowners get told they need a full reline when resurfacing would do the job, or the reverse. Ask for the inspection findings and the reason behind the recommendation. We use the same product lines professional chimney engineers specify, and we’re honest about when the cheaper option is the right one.
- Combine chimney and dryer vent work. Chimneys and dryer vents are your home’s two highest fire-risk venting systems, and handling both on one visit saves you a second appointment. Dryer vent cleaning alongside chimney work is part of what we do.
- Take the free estimate. There’s no charge to have us look and price the work. Call (877) 327-1971 and you’ll get a written estimate that sets the final price, so nothing gets added after the fact.
- Plan around the season you actually burn. If your fireplace sits unused through the hottest months, that’s a fine window to get repair done before the first cool evening you want a fire.
If you’re comparing options, it also helps to know what a repair visit involves end to end. Our St. George page covers local service details, and our team can walk you through what a typical visit looks like for your chimney type. Our technicians have up to 12 years of experience with masonry and factory-built chimneys, and the repair scope means that if we find something during your sweep, we have the parts and skills to fix it the same day rather than handing you a deficiency list and walking away.
FAQs – Chimney Repair Cost
How much does chimney repair cost in St. George?
Most chimney repairs in St. George run $185 to $650 for common fixes like a crown, cap, or flashing, while a flue liner replacement is typically $1,400 to $3,600 and a partial-to-full rebuild is $4,000 to $9,500. The written estimate sets the final price. Call the team at (877) 327-1971 for a free estimate.
Is it cheaper to repair or replace a chimney liner?
Repair is usually cheaper: HeatShield ceramic resurfacing typically runs $1,100 to $2,200, while a full stainless liner replacement is $1,400 to $3,600. Resurfacing works when the existing flue is sound enough to restore, and replacement is the right call when it isn’t. We’ll tell you honestly which one your chimney needs. Call (877) 327-1971 for a free estimate.
Can you come today?
Same-day service is often possible in St. George, and there’s no extra charge for it. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. Call (877) 327-1971 and we’ll get you scheduled.
How much does a chimney leak repair cost in St. George?
Leak repairs usually run $250 to $975, depending on whether the problem is failed flashing at the roof line, a cracked crown, or water getting into the masonry behind it. Finding the source is the whole job, so the estimate follows the inspection. Call (877) 327-1971 for a free estimate.
Why does chimney repair cost more in a high-desert climate?
It doesn’t cost more because of the climate directly, but the climate changes what fails. St. George’s intense sun and wide day-to-night temperature swings open mortar joints and crack crowns faster, so repairs like tuckpointing and crown work come up more often than in a mild climate. Catching them early is what keeps the total down. Call (877) 327-1971 for a free estimate.
Do you charge a service call or diagnostic fee?
No. The estimate is free and the price is set per job by the written estimate once we’ve seen the chimney. There’s no service-call or diagnostic charge to get a number. Call (877) 327-1971 to book your estimate.
Book Your Chimney Repair Estimate
If your crown is cracked, your flashing is leaking, or your liner is giving you second thoughts, the cheapest move is usually the earliest one. We’ll come out, inspect the chimney, and tell you what actually needs fixing versus what can wait. Then we’ll give you a written estimate that sets the final price, and if the parts and skills line up, a lot of repairs get done the same visit. Our technicians have up to 12 years of experience, and we work with the professional-tier product lines that hold up to the St. George climate.
Call (877) 327-1971 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Glacier Chimney Sweep.
Pricing reflects the St. George market as of 2026. Glacier Chimney Sweep offers free estimates – call (877) 327-1971.
What Our Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Doug Parker"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Heather Sullivan"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Laura Doyle